Walker W-400 - Manual (Page 5)

Installation
Base Unit Installation View
Back View–
Wall Mount
Installation
E
N
G
L
I
S
H
CAUTION
1. Never install a telephone during a lightning storm.
2. Never install a telephone in a wet location.
3. Never touch non-insulated telephone wires or
terminals.
4. Use caution when installing a telephone line.
120 VOLT OUTLET/TELEPHONE JACK
1. This phone requires a modular phone jack (RJ11) and
a standard 120 volt outlet
2. Plug AC adapter directly into outlet.
3. Do not plug other appliances into outlet or have outlet
controlled by a wall switch.
WALL MOUNT INSTALLATION
Base unit may be mounted on a standard wall plate.
1. Insert AC adapter into back of base unit.
2. Plug the line cord into modular jack.
3. Mount base on wall plate studs and gently press until
the unit locks in place.
4. Plug AC adapter directly into standard 120 volt outlet.
DESK TOP INSTALLATION
1. Plug the line cord into modular jack.
2. Press unit locking lever clicks.
3. Connect AC adapter into back of unit and plug directly
into standard 120-volt outlet.
ANTENNAS
Adjust base antenna
to upright position.
Standard
AC
Adapter
Modular
Page
Antenna
Dial Mode
Telephone
Line Cord
Charging
Contacts
AC Adapter
Jack
Handset Ringer
On/Off Switch
3
SET TONE/PULSE SWITCH
Set switch (back of base) to correct dialing mode TONE
or PULSE . Please check with local Phone Company if
uncertain of type of service.
RIN G
IN U SE/C HAR GE
H/S RIN GER
PULSE /TONE ON OFF
Handset
Guide