Walker W-400 - Manual (Page 7)

RING
IN USE/CHARGE
Operations
E
N
G
L
I
S
H
4. If battery becomes low while you are on a call, you will
be disconnected after about 2 minutes. Terminate the call
quickly and recharge battery.
To recharge battery pack, place handset in base and:
1. Make sure contact points are touching and CHARGE
LED is lit.
2. Be careful not to short battery with conducting materi-
als such as rings, bracelets and keys.
Extended Battery Life
5 hours Talk time and 8 days in Standby
Replace battery every 2 years. Use only WALKER
EQUIPMENT approved NiCad batteries in your
cordless phone.
ORDERING REPLACEMENT BATTERIES:
Call 1-800-552-3368 to purchase replacement batteries.
5
Flashes: Ringing
Base Antenna
Charging Contacts
CHARGING: Light with
handset in base.
IN USE: Lights when
phone is in use.
Memo Button: Press
to store phone
numbers in memory
or to call a number
you have stored.
Antenna
Receiver Volume
Control: Adjust
listening level.
Neckloop Jack
Temporary Tone (*)
Button: Press to
temporarily change
the dialing mode from
pulse to tone.
Mute Button: Press to
prevent the caller from
hearing outside
conversations.
Talk Button: Lights
to indicate line is in use.
Lights orange when boost
is activated.
Charge Contacts:
For charging the
battery in the
HANDSET.
Channel Button:
Press to change the
operating channel when
you hear interference.
Redial/Pause Button:
Press to redial the last
number you called. (2)
Press to insert a 4-second
pause into the speed
dialing of telephone
numbers.
Flash Button: Lights when
activated.Press to answer
an incoming call if you have
Call Waiting.
Boost Button: Press
to toggle on/off the receiver
volume control feature.
Handset Visual
Ringer: allows you to
see phone ringer when
phone is away from
base unit.
Backlite Keypad: Makes
dialing easier at night
Headset Jack:
Connect to a headset
for hands-free
conversation.