Weider WESY85310 - Manual (Page 11)

11
15. Route the Medium Cable (58) around the “V”-
Pulley (50) on the Right Arm (48). Be sure that
the Cable is in the groove of the Pulley and
that the Long Cable Trap (31) is positioned to
hold the Cable in place. Tighten the 3/8” x 2 1/2”
Bolt (86) and the 3/8” Nylon Locknut (not shown).
Route the Medium Cable (58) around the 3 1/2”
Pulley (15) attached to the Pulley Bracket (20).
Be sure that the Cable is in the groove of the
Pulley and that the Cable Trap (66) holds the
Cable in place. Tighten the 3/8” Nylon Locknut
(21) and the 3/8” x 2” Bolt (not shown). Tighten
the 5/16" x 5” Bolt (68) and the 5/16" Nylon
Locknut (not shown). Be sure that the Pulley
Bracket swivels freely.
16. See the inset drawing. Wrap the Medium Cable
(58) around a 3 1/2” Pulley (15). Attach the Pulley
and a Cable Trap (66) to the upper hole inside
the Long “U”-Bracket (57) with a 3/8” x 2” Bolt
(12) and a 3/8” Nylon Locknut (21).
Be sure that
the Cable is in the groove of the Pulley and
that the Cable and Pulley move smoothly.
Note: This may come pre-assembled.
16
15
58
15
20
68
21
66
86
31
48
15
15
66
12
21
58
58
57
57
50
17. Route the Medium Cable (58) around the 3 1/2”
Pulley (15) attached to the bracket on the Top
Frame (55). Tighten the 3/8” x 2” Bolt (12) and
the 3/8” Nylon Locknut (21). (Note: This Pulley is
pre-assembled. It has been shown disassembled
for easy part identification.)
Be sure that the
Cable is in the groove of the Pulley and that
the Cable and Pulley move smoothly. The
Cable will be attached in step 21.
18. Remove the 3 1/2” Low Pulley (95) from the
Press Frame (17). Reattach the Pulley with the
5/8” x 9/16” Spacer (7) between the Pulley and
the Press Frame.
Hand-tighten the 3/8” Nylon
Locknut (21).
Locate the Short Cable (23). Route the Short
Cable under the 3 1/2” Low Pulley (95).
Be sure
that the end of the Cable with the ball is on
the indicated side of the Press Frame (17) and
that the Cable is between the Pulley and the
crossbar on the Press Frame. Tighten the 3/8”
Nylon Locknut (21) and 3/8” x 3 3/4” Bolt (88).
Route the Short Cable (23) around the 3 1/2”
Pulley (15) attached to the lower hole in the Front
Upright (42).
Be sure that the Cable Trap (not
shown) is turned to hold the Cable in place
and that the Cable is routed around the Pulley
as shown. Tighten the 3/8” Nylon Locknut (21)
and 3/8” x 3 3/4” Bolt (not shown).
17
18
21
12
Bracket
55
58
42
21
21
23 9
88
95
7
Ball
15
Crossbar
17
15