Weider WESY85310 - Manual (Page 9)

9. Wet the handle of one Press Arm (46) with soapy
water. Slide a 5” Plastic Grip (83) onto the han-
dle. Press a 1” Round Inner Cap (49) into the
other end of the handle. Press a 1 3/4” Inner Cap
(44) into the Press Arm.
Attach the Press Arm (46) to one side of the
Press Frame (17) with two 5/16” x 2 1/2” Bolts
(22) and two 5/16” Nylon Locknuts (3).
Assemble the other Press Arm (46) in the same
manner.
10. Identify the Right Arm (48) and the Left Arm (47).
Note the position of the welded bracket on each
Arm.
Arm identification is very important for
step 11.
Attach a “V”-Pulley (50) and a Long Cable Trap
(31) to the Right Arm (48) with a 3/8” x 2 1/2”
Bolt (86) and a 3/8” Nylon Locknut (21).
Attach a “V”-Pulley (50) and a Long Cable Trap
(31) to the Left Arm (47) in the same manner.
9
10
9
44
49
83
46
17
22
3
Handle
46
48
Welded
Bracket 47
50
50
31
31
86
21
11. Lubricate both axles on the Top Frame (55).
Slide the Right Arm (48) onto the right axle. Be
careful not to confuse the Right Arm with the
Left Arm (47); see step 10. Be sure that the
upper end of the Right Arm is behind the indi-
cated bracket on the Top Frame (55).
Tap two 1” Retainers (69) and a 1” Round Cover
Cap (70) onto the axle.
Be sure that the teeth
on the Retainers bend toward the Round
Cover Cap as shown in the inset drawing.
Attach the Left Arm (47) in the same manner.
Press two 1 3/4” Inner Caps (44) into the lower
ends of the Left and Right Arms (47, 48). Wet the
lower end of each Arm with soapy water. Slide a
10” Pad (45) onto the lower end of each Arm.
11
69
70
Lubricate
Axle
55
48
45
69
55
70
Axle
50
47
44
44
Bracket
45