weber Summit 56206 - Manual (Page 9)

WWW.WEbER.com ® 9
tYPe of GAs
Your natural gas grill is factory built to operate using natural gas only . Never attempt to
operate your grill on gases other than the type specified on the grill rating plates .
Your grill operates at 4.5" of water column pressure. If replacement of the hose becomes
necessary, factory specified parts are required . See your local dealer .
For safety and design reasons, the conversion of a Weber ® grill from operation using
Natural gas to operation using LP gas requires the change out of the entire gas
supply system of the grill . If this becomes necessary, see your dealer for additional
information .
◆
whAt is nAtUrAL GAs?
Natural gas, often called methane, is a safe modern fuel . Natural gas is supplied by your
local utility and should be readily available if your house is already heated with gas .
◆
PortAbLe instALLAtion
Weber ® recommends moving the grill at least two feet from the gas supply and any
combustible surfaces . After the gas supply has been run and checked for leaks in
accordance to the assembly instructions, you are ready to grill . To connect the hose
to the gas supply, pull back the outer fitting, insert the hose fitting all of the way, and
release the outer fitting . This process will produce a gas joint .
◆
1 Swivel Connection
2 Install covers when hose is disconnected
3 Shut Off Valve
4 Coat this pipe nipple with gas resistant pipe dope
5 Socket
6 Male Connection
1 Socket
2 Sleeve
3 Push Sleeve Back
4 Plug
Push plug until sleeve snaps forward locking plug in socket .
(This turns on gas automatically .)
When properly assembled the plug cannot
be removed without pushing the sleeve back .
To disconnect, push sleeve back and pull out plug .
(This automatically shuts off gas .)
GAS INSTRUcTIoNS