Whirlpool Residential Gas Water Heater with the Flame Lock Safety System - Manual (Page 30)

30
REPAIR PARTS ILLUSTRATION
1
2
3
4
8
5
10
11
9
7
6
Item
No.
Parts Description
1 DRAFT HOOD
2 REDUCER RING - SOME MODELS
3 FLUE BAFFLE
4 HEAT TRAP (COLD) - SOME MODELS
5 HEAT TRAP (HOT) - SOME MODELS
6 COLD WATER DIP TUBE
7 ANODE ROD
8 TEMPERATURE & PRESSURE RELIEF VALVE
(LOCATED TOP OR SIDE)
9 DRAIN VALVE
10 GAS CONTROL VALVE/THERMOSTAT
(with thermal switch wire lead)
10 CONTROL MODULE
11 OUTER DOOR
12A* PILOT/THERMOPILE ASSEMBLY KIT
12B* PILOT/THERMOPILE ASSEMBLY KIT ( L.P. Cast Burner)
13A* BURNER (Natural Gas/Low Nox)
13B* L.P. CAST BURNER
14A* MANIFOLD DOOR ASSEMBLY
14B* MANIFOLD DOOR ASSEMBLY ( L.P. Cast Burner)
15* MANIFOLD COMPONENT BLOCK
16* MANIFOLD DOOR GASKET
17* VIEWPORT ASSEMBLY
*Pictured on next page.
When ordering repair parts always give the following
information:
1. Model, serial, and product number
2. Type of gas
3. Item
number
4. Parts description
Repair Parts List
LEGEND
Special anode rod (see page 21)
Temperature and Pressure Relief Valve is required,
but may not be factory installed
Unique: Flame Lock ® Safety System parts