Weider WESY59101 - Manual (Page 17)

17
43. Locate the Leg Press Cable (75). Attach the Leg
Press Cable to the indicated side of the Press
Upright (2) with a 3/8” x 3 1/4” Bolt (62) and a 3/8”
Nylon Locknut (50). Do not tighten the Nylon
Locknut yet.
Wrap the Leg Press Cable (75) up around a 3 1/2”
Pulley (24) in the direction shown. Attach the 3 1/2”
Pulley and a Cable Trap (25) to the indicated side
of the Press Frame (8) with a 3/8” x 4 3/4” Bolt (60)
and a 3/8” Nylon Locknut (50). Do not tighten the
Nylon Locknut yet. Be sure that the Cable Trap
is turned to hold the Cable in place.
44. Wrap the Leg Press Cable (75) around a 3 1/2”
Pulley (24) in the direction shown. Attach the 3 1/2”
Pulley and a Cable Trap (25) to the indicated side
of the Press Seat Frame (7) with a 3/8” x 4 3/4” Bolt
(60) and a 3/8” Nylon Locknut (50). Do not tighten
the Nylon Locknut yet. Be sure that the Cable
Trap is turned to hold the Cable in place.
45. Wrap the Leg Press Cable (75) around a 3 1/2”
Pulley (24) in the direction shown. Attach the 3 1/2”
Pulley and a Cable Trap (25) to the indicated side
of the Press Leg Lever (90) with a 3/8” x 4 3/4” Bolt
(60) and a 3/8” Nylon Jamnut (63). Do not tighten
the Nylon Locknut yet. Be sure that the Cable
Trap is turned to hold the Cable in place.
46. Wrap the Leg Press Cable (75) around a 3 1/2”
Pulley (24). Attach the 3 1/2” Pulley and a Cable
Trap (25) to the indicated side of the Press Base (6)
with a 3/8” x 5 1/2” Bolt (55) and a 3/8” Nylon
Locknut (50). Do not tighten the Nylon Locknut
yet. Be sure that the Cable Trap is turned to
hold the Cable in place.
Wrap the Leg Press Cable (75) around another
3 1/2” Pulley (24). Attach the 3 1/2” Pulley between
the Small Pulley Plates (22) with a 3/8” x 1 3/4” Bolt
(57) and a 3/8” Nylon Locknut (50) that was
removed in step 40. Be sure the Leg Press Cable
is routed so that it crosses from one side of the
Press Base (6) to the other.
46
43
44
45
62
2
7
25 8
50
75
60
75
50
24
55
22
57
50
25
50
7
24
63
90
75 25
60
24
75
24
60
25
6