Weider WESY59101 User Manual
Page 20
Before using the weight system, pull each cable a few times to be sure that the cables move smoothly over
the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If the
cables are not properly installed, they may be damaged when heavy weight is used. See the CABLE
DIAGRAMS on page 25 and 26 of this manual for proper cable routing. If there is any slack in the
cables, you will need to remove the slack by tightening the cables. See TROUBLESHOOTING AND
MAINTENANCE on page 24.
20
55
56
57
91
46
3
39
55. Lubricate a 1/2” x 4” Bolt (68). Attach the Foot
Press Plate (29) to the Press Leg Lever (90) with
the Bolt and a 1/2” Nylon Jamnut (36).
56. Press two 3/4” Round Inner Caps (43) into each of
the two Pad Tubes (42).
Slide a Foam Pad (30) onto one side of a Pad Tube
(42). Slide the Pad Tube through the hole in the
Leg Lever (41). Slide another Foam Pad onto the
other side of the Pad Tube.
Slide a Foam Pad (30) onto one side of the other
Pad Tube (42). Insert the Pad Tube through the
welded tube on the Butterfly Front Leg (3). Slide
another Foam Pad onto the other side of the Pad
Tube.
57. Attach the Curl Pad (91) to the Preacher Post (39)
with four 1/4” x 3/4” Bolts (49).
Slide the Preacher Post (39) into the Butterfly Front
Leg (3) and secure it by inserting the Large
Adjustment Knob (46) and turning it clockwise until
tight.
58. Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in
ADJUSTMENTS, beginning on page 21 of this manual.
41
30
Welded
Tube
30
43
42
42
3
90
29
Lubricate
68
36
49
49