Whirlpool 2195258 - Manual (Page 22)

20
Attaching the optional ice maker to a
water supply
Read all directions carefully
before you begin.
w WARNING
Electrical Shock Hazard
Unplug the refrigerator before
installing ice maker.
Failure to do so can result in death
or electrical shock.
IMPORTANT:
• Use copper tubing only and check for
leaks.
• Install ice maker tubing in areas where
temperatures are above freezing.
Tools required:
• Standard screwdriver
• 7 ⁄
16
-inch and 1 ⁄
2
-inch open-end wrenches
or two adjustable wrenches
• 1 ⁄
4
-inch nut driver
• 1 ⁄
4
-inch drill bit
• Hand drill or electric drill (properly
grounded)
NOTE: Your appliance dealer has a kit
available with a 1 ⁄
4
-inch saddle-type shut-off
valve, a union, and copper tubing. Before
purchasing, make sure a saddle-type valve
complies with your local plumbing codes. Do
not use a piercing-type or
3 ⁄
16
-inch saddle
valve which reduces water flow and clogs
more easily.
Cold water supply
The ice maker water valve contains a flow
washer which is used as a water pressure
regulator. The ice maker needs to be
connected to a cold water line with water
pressure limitations of 20-120 psi. If a
problem occurs, call your utility company.
IMPORTANT:
• It may take up to 24 hours for your ice
maker to begin producing ice.
• If operating the refrigerator before install-
ing the water connection, turn ice maker to
the OFF position to prevent operation
without water.
• All installations must be in accordance with
local plumbing code requirements.
Installation is not warranted by
refrigerator or ice maker
manufacturer.