weber Summit Gas Grill S-460 - Manual (Page 28)

28
LoCating YoUr LP tanK EnCLoSUrE Kit
When determining a suitable location for your LP Tank Enclosure Kit installation, give
attention to concerns such as proximity to traffic paths, and keeping any gas supply
lines as short as possible. Never locate the Summit
® LP Tank Enclosure Kit in a garage,
breezeway, shed, under an unprotected overhang, or other enclosed area. Locate the LP
Tank Enclosure Kit and structure so there is enough room to safely evacuate the area in
case of a fire.
1
1
1
c
a
b b
CLEaranCE from CombUStibLE SUrfaCES or
StrUCtUrES
m warning: Clearance from the outside walls of the sides
and back of the LP tank Enclosure must be a minimum of
24" (60.96cm) any surface. refer to “typical gas Supply
installation” before starting installation.
m warning: the structure, “island” counter tops and
adjacent work areas for the LP tank Enclosure must be
built from noncombustible materials only.
NOTE: If you have questions on what materials are considered noncombustible, contact
you local building supplier or fire department.
m dangEr
Use of any other hose and regulator assembly could be
dangerous, and may not provide adequate gas supply to
the Summit
® built-in gas grill, and could result in a fire or
an explosion causing serious bodily injury or death and
damage to property.
m dangEr
failure to build a LP cylinder enclosure for a 20 lb cylinder
following the requirements for ventilation, cylinder retention
and separation of the LP cylinder from a heat source, listed
in the anSi Standard for outdoor Cooking gas appliances,
anSi Z21.58 CSa 1.6, could be dangerous, and could result
in a fire or an explosion causing serious bodily injury or
death and damage to property.
if you do not follow the dangEr statements exactly, the warranty on the Summit ®
built-in gas grill will be voided.
BUilT-in TanK EnClOsUrE insTrUCTiOns
EnClOsUrE CharT
1 24˝ inches (610 mm) Any Surface
a LP Tank Enclosure
b Any Surface
c Non-Combustible Surface
www.wEBEr.COM ®