Weider 831.150730 - Manual (Page 8)

8
7. Press 25.4mm Square Inner Caps (12) into the
indicated ends of each Backrest Tube (5).
With the help of a second person, slide the indi-
cated ends of the Backrest Tubes (5) onto the
welded axle on the Frame (2). Attach each
Backrest Tube to the Backrest (6) with two M6 x
38mm Screws (16) and two M6 Washers (25).
The Backrest Tubes must be oriented on the
outside of the welded axle as shown.
Do not tighten the four Screws (16) yet.
8. Lift the Backrest (6) and insert the end of the
Support Rod (7) without the locking clip through
the Uprights (1). Rotate the locking clip into place
around the right Upright. Rest the Backrest on the
Support Rod.
When moving the Support Rod (7), always
make sure that the locking clip is in place
around the right Upright (1).
Rest the Backrest (6) on the Support Rod (7).
See step 7. Tighten the four M6 x 38mm
Screws (16) securing the Backrest Tubes (5)
to the Backrest (6).
Tighten the Nylon Locknuts (13) used in step 1.
9. Attach the Seat (11) to the brackets on the Frame
(2) with four M6 x 16mm Screws (15).
1
1
6
7
8
2
11
28
15
29
15
9
10
10. Attach the Curl Pad (29) to the Curl Post (28) with
two M6 x 16mm Screws (15).
Note: The Curl Post (28) can be stored in the
leg lever. See page 11.
16
25
5
12
2
Welded
Axle
6
12
25
25
16
16
7