Whistler 1790SE - Manual (Page 11)

OPERATION OPERATION
19
• Press and release the (Quiet/Record) button to begin
a recording. Note: Recording starts as soon as the button
is released. Display reads:
REC = record, 1 = track #, 8 = time remaining
If the recording time expires for a track, the unit will auto-
matically switch to the next track. Press and release
(Quiet/Record) again to stop recording. The unit will
automatically stop recording once track 9 is completed.
To play a message:
• Enter Memo mode and press (Power/Play) to listen to
recorded messages.
• To play a selected track, press (Volume Up) or
(Volume Down) button until selected track appears on
the display. Display reads:
PLY = play, 1 = track #, 8 = time remaining
• Press the (Power/Play) button.
Messages are kept in memory and are not affected by
resetting the factory features. See “Reset Features” sec-
tion of the manual.
To delete a message:
• Enter Memo mode and press (Volume Up) or
(Volume Down) button until selected track appears on
the display.
• Press the (Quiet/Record) button twice.
18
To exit Memo mode:
• Press memo button and release. The unit will beep twice.
NOTE: Memo mode automatically exits within 20 seconds
if a button is not pressed.
Vehicle Battery Saver Mode
The Vehicle Battery Saver Mode automatically shuts off
your detector within 3 hours if you forget to turn it off. The
timer is reset if the detector is turned off, unplugged or
any button is pressed before the 3 hours have expired. The
detector will alert you with an audible and visual warning
before it shuts off. Display reads:
During this warning you can momentarily reset the unit by
pressing any button. This will reset the timer.
If the unit has automatically turned itself off, press the
(Power/Play) button to turn the unit back on. You can
manually engage the Vehicle Battery Saver Mode by press-
ing and holding the City button until one beep is heard.
Refer to “Option Select Mode” for instructions for deacti-
vating battery saver mode feature.
Vehicle Battery Monitor
The vehicle’s battery voltage can be momentarily dis-
played by pressing and holding the Mode button for 3 sec-
onds. Display reads:
12.8 V