Weider WESY09321 - Manual (Page 5)

5
Before beginning assembly, carefully read the
following information and instructions:
• Assembly requires two people.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• As you assemble the weight system, make sure
all parts are oriented as shown in the drawings.
• For help identifying small parts, use the PART
IDENTIFICATION CHART in the center of the
manual.
The following tools (not included) are required
for assembly:
• Two adjustable wrenches
• One rubber mallet
• One standard screwdriver
• One Phillips screwdriver
• Lubricant, such as grease or petroleum jelly,
and soapy water.
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
Make Things Easier for Yourself
Everything in this manual is designed to ensure
that the weight system can be assembled suc-
cessfully by anyone. However, it is important to
realize that the versatile weight system has
many parts and that the assembly process will
take time. Most people find that by setting aside
plenty of time, assembly will go smoothly.
ASSEMBLY
1.
Press two 45mm Square Inner Caps (42) into the
ends of the Base (1).
Attach two Plastic Feet (53) to the Base (1) with
two M4 x 16mm Screws (56).
Attach a Wheel (31) to the outside of the Base (1)
with an M10 x 103mm Bolt (81), three M10
Washers (75), and an M10 Nylon Locknut (76).
Do not overtighten the Locknut; the Wheel
must be able to turn easily.
Attach the other Wheel (31) to the Base (1) in
the same manner.
2. Attach the Base Plate (2) to the Base (1) with two
M4 x 16mm Screws (56).
Before beginning assembly, make sure you
have read and understood the information in
the box above. This brief introduction will
save you more time than it takes to read it.
1
2
1
42
31
31
75 76 42
75
81
56
2
56
1
53
53