Weider WESY09321 - Manual (Page 7)

7
7. Set the Top Frame (9) on the Upright (4) and the
Rear Upright (8).
Attach the Top Frame (9) to the Upright (4) with
an M10 x 66mm Bolt (79) and an M10 Washer
(75).
Attach the Top Frame (9) to the Rear Upright (8)
with an M10 x 61mm Button Head Screw (85),
two M10 Washers (75), and an M10 Nylon
Locknut (76).
8. Press two 38mm Round Inner Caps (40) into the
ends of the Crossbar (10).
Attach the two Eyebolts (34) to the Crossbar (10)
with two M8 Washers (59) and two M8 Nylon
Locknuts (65). Do not overtighten the Locknuts;
the Eyebolts must be able to rotate freely.
Attach the Crossbar (10) to the Top Frame (9)
with two M10 x 54mm Bolts (70), two M10
Washers (75), and two M10 Nylon Locknuts (76).
Be sure the Crossbar is attached as shown in
the inset drawing. If the ends point away from
the Top Frame, turn the Crossbar around and
reattach it.
8
7
8
85
9
75
75
76
79
4
10
75
70
76
9
65 59
40
40
59
65
34
34
6. Press two 25mm Round Inner Caps (39) into the
ends of the tube on the Weight Carriage (18).
Orient the Weight Carriage (18) as shown. Slide
the Weight Carriage onto the Rear Upright (8).
6
39
18
8
39
10
9