Weider 831.150360 User Manual
Page 6
6
3.
Attach the Cross Brace (21) to the Left Upright (1)
with two M8 x 68mm Bolts (8), two M8 Washers (2),
and two M8 Nylon Locknuts (7).
Use the upper two
holes, as shown.
Attach the Cross Brace (21) to the Right Upright
(22) with two M8 x 68mm Bolts (8), two M8
Washers (2), and two M8 Nylon Locknuts (7).
Tighten all M8 Nylon Locknuts (7) used in steps
2 and 3.
4.
Press a 1” Round Inner Cap (14) into each end of
the Adjustment Tube (13).
Set the Adjustment Tube (37) into one set of adjust-
ment brackets on the Left and Right Uprights (1,
22).
5.
Lubricate an M10 x 75mm Bolt (5). Attach the
Bench Frame (19) to the Cross Brace (21) with the
M10 x 75mm Bolt and an M10 Nylon Locknut (4).
The Bench Frame must be turned as shown. Do
not overtighten the Nylon Locknut.
Attach the Bumper (24) to the Bench Frame (19)
with an M4 x 25mm Screw (10).
Press a 38mm x 50mm Inner Cap (16) into the
Bench Frame (19).
6.
Press a 38mm x 50mm Inner Cap (16) into each
end of the Front Leg (20).
Lubricate an M10 x 75mm Bolt (5). Attach the Front
Leg (20) to the Bench Frame (19) with the M10 x
75mm Bolt and an M10 Nylon Locknut (4).
Do not
overtighten the Nylon Locknut.
6
3
4
7
7
2
2
1
22
8
8
21
Do not
use these
Holes
1
22
Adjustment
Brackets
14
14
13
5
4
21
19
24
16
10
Lubricate
5
16
16
19
20
4
5
Lubricate