Wright Manufacturing 14SH654 - Manual (Page 16)

15
Seat Adjustments
The Sport X seat is equipped with the ability to
adjust the seat up and down as well as lock the
seat in the down position to avoid seat bounce
while standing. (Figure 1)
Height Adjustment:
•
Loosen lower seat mounting hardware,
•
Removing upper bolts. (Fig. 1A)
•
Raise or lower seat to desired setting
and re-install the upper bolts in the
corresponding hole.
•
Tighten all hardware.
Seat Lock:
•
Loosen T-Knob (Fig. 1B)
•
Slide up to top of slot and lock T-Knob to
lock seat in position.
•
To fold seat forward, loosen T-Knob and
slide to bottom of slot.
Hydro Oil Tank Check/Fill
Checking oil
•
Ensure mower is on a level surface.
•
Remove hex socket plug from oil level port on
the front of the tank. Location is behind the
engine attached to the front of the upright
assembly.
•
Hydro oil should be at the bottom of the threads.
Filling oil
•
Remove hex socket plug.
•
Using a funnel, fill tank through oil level port until
oil reaches bottom threads of the port.
Lubrication
Grease with No. 2 general purpose lithium base or
molybdenum base grease.
•
Set parking brake, stop the engine and
remove the key.
•
Clean grease fittings with a rag.
•
Connect grease gun to fitting and pump until
grease begins to ooze out from the
bearings.
•
Wipe off excess grease.
•
Do not use spray lube of any kind on choke
and/or throttle cables.
Service intervals: First 8 hours
Every 25 hours
Also see Maintenance chart
How to Move the Mower if the Engine
Won’t Start
Rotate both of the hydro bypass valves on the side
of each hydraulic pump about ½ turn
counterclockwise. It is important not to over
tighten these. Damage may occur to the pump if
this valve is over tightened.
Fill Here
Figure 1
A
B