Wright Manufacturing 14SH654 - Manual (Page 18)

17
Critical Application Models
Thread
Locker
Torque
Range (ft-lbs)
Wheel motor bolts (Securing
motor to support) Big/Small Stander, Stander X, Sport X,
RH, WSES, Velke Loctite
2760
40-50
Wheel motor bolts / nuts
(Securing motor to support)
ZK, MMZ, Sentar3 N/A 103-125
Clutch to engine shaft All Models Loctite 50-55
Big Stander, Stander X, Sport X (15P) 138-158
ZK, MMZ, Sentar3 (15E) 160-240
All Others (12P) 138-158
Wheel lug nuts All Models N/A 80-90
Split Hub (Spindle & Drive) (Gr 8) All Models N/A 13-17
Blade Bolts All Models N/A 70-80
N/A Wheel hub to wheel motor
Torque Specifications
Spindle and Drive Pulley Split hub R&R
•
Remove 2, ¼” bolts from split hub and install in threaded holes in hub.
•
Slowly tighten each bolt, alternating as you tighten bolts against the pulley.
•
The hub will separate from the pulley.
•
Replace grade 8 bolts and install in reverse order using the assembly holes to tighten hub onto pulley
and spindle shaft.
Spindle Set Up / Blade Options
Parts:
Assembly
hole
Threaded
Removal
holes
Assembly
hole
Tightening will
separate the hub
from the pulley
Spindle – Thru Bolt
PN - 71460126
Spindle Washer
PN - 13990039
Spindle Blade Spacer
PN – 13990007 / 3 or 5 ea
Spindle Nut
PN - 12990003
Spindle Blade Spacer
PN – 13990007 / 1 or 3 ea
Stock Fusion Blade
PN – 71440008 – 16.5”
71440009 – 18”
71440010 – 21”