Weider 831.150290 - Manual (Page 6)

Before beginning assembly, carefully read the
following information and instructions:
• Assembly requires two people.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• As you assemble the weight bench, make sure all
parts are oriented as shown in the drawings.
• For help identifying small parts, use the PART
IDENTIFICATION CHART on page 5.
The following tools (not included) are required
for assembly:
• Two adjustable wrenches
• One rubber mallet
• One standard screwdriver
• One Phillips screwdriver
• Lubricant, such as grease or petroleum jelly,
and soapy water.
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
Make Things Easier for Yourself
Everything in this manual is designed to ensure
that the weight bench can be assembled suc-
cessfully by anyone. However, it is important to
realize that the versatile weight bench has many
parts and that the assembly process will take
time. Most people find that by setting aside plen-
ty of time, assembly will go smoothly.
6
ASSEMBLY
1
27
11
11
16
16
16
1
1
Warning
Decal
31
1. Before assembling the weight bench, be sure
that you have read and understand the infor-
mation in the box above.
Press three 50mm Square Inner Caps (16) into
the Upright (1) without the warning decal.
Attach two Joint Plates (11) to the Upright (1) with
two M10 x 68mm Bolts (27) and two M10 Nylon
Locknuts (31). Do not tighten the Locknuts yet.
Repeat this step with the other Upright (1).
Make sure the Joint Plates (11) are oriented as
shown in the inset drawing.