Weider 831.150290 - Manual (Page 7)

7
4
31
28
Hexagon
Holes
30
30
3
4
2. Attach the Crossbar (2) to an Upright (1) with two
M10 x 68mm Bolts (27), two Joint Plates (11),
and two M10 Nylon Locknuts (31). Do not tight-
en the Locknuts yet.
Repeat this step with the other Upright (1).
3. Press three 50mm Square Inner Caps (16) into
the Front Leg (4) and the Stabilizer (5).
Attach the Front Leg (4) to the Stabilizer (5) with
two M10 x 60mm Carriage Bolts (26) and two
M10 Nylon Locknuts (31). Do not tighten the
Locknuts yet.
4. Attach the Front Leg (4) to the Bench Frame (3)
with two M10 x 50mm Bolts (28), two M10
Washers (30), and two M10 Nylon Locknuts (31).
Do not tighten the Locknuts yet. Make sure
the bolt heads fit inside the hexagon holes in
the Bench Frame.
3
2
27
11
2
1
31
5
16
16
16
4
26
31
31
1