Windsor Saber Compact 22 - Manual (Page 14)

14
English
The table given below gives details of the
factory settings of the parameters for the cle-
aning programs. If no values are entered,
then the respective parameter cannot be set
in the given cleaning program.
To improve the vacuuming result on tiled
floors the squeegee tool can be turned to an
oblique position of up to 5°.
Î
Release the wing nuts.
Î Turn the squeegee tool.
Î Tighten the wing nuts.
If the results are is unsatisfactory the inclina-
tion of the straight squeegee tool can be mo-
dified.
Î
Release the wing nuts.
Î Tilt the squeegee tool.
Î Tighten the wing nuts.
The appliance is equipped with an auxiliary
traction drive with free wheel. The appliance
can also be moved by hand on account of
the free wheel.
Î Release emergency-stop button by
turning.
Î Turn the main switch from position 0 to 1.
Î Switch on "traction" button.
Display and battery indicator display are ac-
tivated.
Î
Press control switch.
The appliance accelerates and then drives
at the transport speed (4 km/h / 2.5 mph))
Î
Release the control handle.
The appliance brakes.
Î Release emergency-stop button by
turning.
Î Turn the main switch from position 0 to 1.
Display and battery indicator display are ac-
tivated.
Factory setting
Detergent metering C
le
ans
pee
d
F
ACT
(b
ru
sh
sp
eed
)
Scrubbing suction 1 3 P
Wet scrubbing
Dry vacuum cle-
aning
– –
Polishing P
Polish suction
Driving
– –
*) Only Saber Compact 22 SP: P=Power
Clean
Setting the Squeegee Tool
Oblique position
Inclination
Traction drive
Program selection switch in "Driving"
position:
Program selection switch to cleaning
program (position 2...6)