Whistler 1670LD - Manual (Page 10)

Memo Mode
Record up to 3 distinct message tracks for a total of 45
seconds, one 45 second message or any combination in
between.
IMPORTANT: Unit does not detect radar or laser signals
during recording or while playing a memo.
WARNING!!! Memo mode is not intended to be used
while you are driving. You should not use any device in a
vehicle that may distract you from observing the road
ahead.
To record or play a message (Memo mode):
• Press (Volume Up) and (Volume Down) buttons sim-
ultaneously and release. The unit will beep twice while
flashing the X & V/L icons; this enters Memo mode. Display
shows:
OPERATION OPERATION
• Press and release the (Quiet/Record) button to begin
a recording. Note: Recording starts as soon as the button
is released. Display shows:
If the recording time expires for a track, the unit will auto-
matically switch to the next track. Press and release
(Quiet/Record) again to stop recording. The unit will
automatically stop recording once track 3 is completed.
To play a message:
• Enter Memo mode and press (Power/Play) to listen to
recorded messages.
• To play a selected track, press (Volume Up) or
(Volume Down) button until selected track appears on
the display. Display shows:
• Press the (Power/Play) button.
Messages are kept in memory and are not affected by
resetting the factory features. See “Reset Features” sec-
tion of the manual.
To delete a message:
• Enter Memo mode and press (Volume Up) or
(Volume Down) button until selected track appears on
the display.
• Press the (Quiet/Record) button twice.
16 17
II = Track 2
Selected
Blinking
1670LD manual 4/11/02 11:48 AM Page 19