Wolfgang Puck BBLFP050 - Manual (Page 11)

20
Maintenance and Cleaning
CAUTION: To avoid a laceration hazard, extreme care must be used
when handling discs, blades and blade assemblies. They are precision-
honed and extremely sharp.
• Turn the power switch off, located on the right side of the Food
Processor Motor Housing. Remove the plug from the wall outlet.
Food Processor
• If using the Processing Blade, remove from the Accessory Shaft,
press the two side lock tabs in, and carefully the lift the blade off the
Shaft. See Figure 12. If using the Cutting Discs, remove from the
Spindle by grasping from the white center ring and lifting straight
up.
• Clean the Mixing Bowl, Lid and all the Accessories, except the Motor
Housing with warm, soapy water and dry thoroughly. You can also
clean the Accessories in the top rack of your dishwasher.
CAUTION: Be careful when attaching and removing accessories. The
Processing Blade, the Slicing Disc and Shredding Disc are sharp.
• Clean the Motor Housing and the Power Cord with a damp cloth and
dry thoroughly.
• Make sure no moisture comes into contact with the appliance’s
electrical parts, never immerse the appliance, the Power Cord or the
plug in water or other liquids.
• Never use aggressive or abrasive cleaning products or sharp objects
(such as a knife or a hard brush) to clean the appliance.
19
Maintenance and Cleaning cont.
Blender
• You can use the frozen drink mode to clean the Blender Jar
by placing two cups of warm water in the Jar with a drop of
dishwashing detergent. Let the Blender run for the full cycle.
Rinse and repeat if necessary.
• If food is stuck to the Blade Assembly, you can remove it from
the Blender Jar for cleaning. The Filler Cap also acts as a Blade
Assembly removal tool. Turn the Blender upside down and place
the open end of the Filler Cap over the center of the blade. Make
sure no moisture comes into contact with the appliance’s electrical
parts. Turn the Filler Cap clockwise about one-half inch until it
stops turning. Remove the Blade Assembly by grasping the
white Accessory Shaft and lifting out of the Jug. Angle the
Blade Assembly to remove.
• To replace the Blade Assembly, ensure that the Silicone Gasket is
properly placed over the Blade Assembly. Line up the four cutouts
on the Blade Assembly with the four tabs on the Blender Jug. Use
the Filler Cap to lock the blade into place by turning counter
clockwise about a half inch until it stops.
• The Blender Jug with Blade Assembly, Lid and Filler Cap can be
washed in warm, soapy water or placed in the top rack of the
dishwasher.
Citrus Juicer
• Remove the Reamer, Strainer, Accessory Shaft, and Mixing Bowl and
clean these parts with warm soapy water and dry thoroughly. These
parts can also be placed in the top rack of your dishwasher.
• The Motor housing can be cleaned with a damp cloth. Do not
immerse into any liquid.
Figure 16
Figure 17
Storage
1 Place the discs in the storage tray at the
bottom of the Motor Housing as shown in
figures 16 and 17.
2 Push the Power Cord into the storage space
at the back of the appliance.
HSN_3n1BlenderManual 6/25/10 11:08 AM Page 19