Weslo MOMENTUM WLEL7397.1 - Manual (Page 6)

6
4. The Console (22) requires two 1.5V “AA” batter-
ies (not included). Remove the battery cover
from the Console and insert two batteries into
the battery compartment. Make sure that the
batteries are oriented as shown by the dia-
gram inside the battery compartment. Then,
reattach the battery cover.
Have a second person hold the Console (22)
near the Upright (3). Connect the console wire
to the Upper Wire (75). Connect the two pulse
wires on the console to the Pulse Wires (74).
Insert the excess wire downward into the
Upright.
Attach the Console (22) to the Upright (3) with
four Console Screws (68). Be careful to avoid
pinching the wires.
3. While another person holds the Upright (3) near
the Frame (1), connect the Upper Wire (75) to
the Reed Switch Wire (67). Next, connect the
Resistance Cable (12) to the Lower Cable (70)
in the following way:
See drawing A. Pull up on the metal bracket
(A) on the Lower Cable (70), and insert the tip
of the Resistance Cable (12) into the wire clip
located inside the metal bracket.
See drawing B. Firmly pull the Resistance
Cable (12) and slide it into the metal bracket (A)
on the Lower Cable (70) as shown.
See drawing C. Using pliers, squeeze the
prongs on the upper end of the metal bracket
(A) together.
Slide the Upright (3) onto the Frame (1). Be
careful to avoid pinching the cables or the
wires. Align the holes in the Upright with the
holes in the Frame. Attach the Upright with six
M8 x 5/8" Hex Bolts (45) and six M8 Arc
Washers (54).
22
3
68
75
74
Console Wire
Pulse Wires
45
67
54
1
12
45
54
54
70
75
45
A B C
A
A
A
12
12
70
70
Battery
Compartment
4
3
3