Wells WM-TR II - Manual (Page 3)

WARRANTY xi
SPECIFICATIONS 1
FEATURES & OPERATING CONTROLS 2
PRECAUTIONS & GENERAL INFORMATION 4
AGENCY LISTING INFORMATION 4
INSTALLATION 5
OPERATION 9
CLEANING INSTRUCTIONS 10
TROUBLESHOOTING SUGGESTIONS 12
PARTS & SERVICE 13
CUSTOMER SERVICE DATA 13
Thank you for purchasing this Wells Manufacturing Co. appliance.
Proper installation, professional operation and consistent maintenance of this appliance will ensure that it
gives you the very best performance and a long, economical service life.
This manual contains the information needed to properly install this appliance, and to use and care for the
appliance in a manner which will ensure its optimum performance.
TABLE OF CONTENTS
Electrical:
208 Volts, Single Phase 30 Amps
240 Volts, Single Phase 27 Amps
NOTE: Requires a dedicated 40 Amp circuit
Plumbing:
Water Inlet: 1/4” Male Flare Fitting
Supply: 1/4” Female Flare supplied by a 1/4” O.D. or larger water supply line
NOTE: If water supply run from main supply line to Water-Max™ exceeds 12 feet,
a 3/8” O.D. or larger water supply line is required.
IMPORTANT:
This dispenser must be installed in compliance with all applicable
federal, state and local codes and ordinances.
Dimensions: Height:
32-5/8”
Width: 13-1/8” (with satellite installed)
Depth: 20-3/4” (without satellite) 24” (with satellite installed)
Weight: 55 lbs. (heater assembly only, dry) 20 lbs. (satellite only, dry)
146 lbs. (operating configuration - filled, with satellite installed & filled)
62 lbs. (satellite only, filled)
SPECIFICATIONS
INTRODUCTION
1
M
707
p
/n
30669
2
OpM
anual
W
M
-T
R II