Whistler PP150AC - Manual (Page 6)

OPERATION
Making the Connection.
The PP150AC is designed to connect to your 12 volt battery
t h rough the cigarette lighter socket on your dashboard .
(See the following section for instructions for connecting the
P P 3 5 0 A C ) .
To connect the 150 inverter, follow these steps:
1.
Remove the cigarette lighter and push the adapter
plug firmly into the cigarette lighter socket. (Make
certain both the socket and adapter plugs are clean).
2. Plug your appliance or equipment into the AC
receptacle on the inverter.
3. Turn the inverter rocker switch to the ON (l) position.
4. Confirm that the LED Power Indicator light on the
inverter is glowing GREEN. This GREEN light indi-
cates that your WHISTLER inverter is "ready for
action."
5. Turn on your appliance or power equipment.
The PP350AC is designed to connect to your 12 volt battery
either through the cigarette lighter socket or directly to the
b a t t e ry using the supplied Hard Wi re Adapter Kit.
To connect the PP350AC with the cigarette lighter adapter
plug and cord, follow the steps as outlined above.
Note:
•
If the equipment or appliance you intend to operate,
requires more than 150 watts of continuous power, the
PP350AC should be connected directly to the power
source using the Hard Wire Adapter Kit. Failure to
do so may result in serious damage to the power cord
or to the cigarette lighter socket wiring.
9
OPERATION
8
To connect the PP350AC using the Hard Wire Adapter
Kit (P/N PP010DC), follow these steps:
1. Push the adapter plug leading from the inverter firm-
ly into the Hard Wire Adapter Kit socket.
2. Properly identify the positive and negative terminals
on the 12 volt power source and make certain that the
terminals are clean and dry.
3. Connect the RED alligator clip to the Positive (+) ter-
minal on the power source and the BLACK alligator
clip to the Negative (-) terminal on the power source.
4. Plug your equipment or appliance into the AC recep-
tacle on the inverter.
5. Turn the inverter’s rocker switch to the ON (l) position.
6. Confirm that the LED Power Indicator light on the
inverter is glowing GREEN. This GREEN light indi-
cates that the inverter is "ready for action."
7. Turn on the equipment or appliance.