Wyse Technology 3820TX User Manual
Page 7
vii
Class B
This digital apparatus does not exceed the Class B limits for radio noise emissions from
digital apparatus set out in the Radio Interference Regulations of the Canadian
Department of Communications.
Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites
applicables aux appareils numériques de la classe B prescrites dans le Réglement sur le
brouillage radioélectrique édicté par le Ministère des Communications du Canada.
IEC/EN Notice
These products conform to the requirements of IEC950 and EN60950.
These products conform to requirements of EN55022 for Class A equipment or EN55022
for Class B equipment (refer to "Terminal Requirements Compliance").
Cable Notice
The use of shielded I/O cables is required when connecting this equipment to any and all
optional peripheral or host devices. Failure to do so may cause interference and violate
FCC and international regulations for electromagnetic interference.
Device Power Supply
Caution
Replace power supply with the same or equivalent type as recommended by
the manufacturer.
Model 3820TX
For use with External Power Supply EDAC Model EA1060A or certified equivalent model
supplied by the manufacturer, rated minimum 16/3.5A.
Battery Information
The Model 3820TX terminal contains a replaceable battery (for battery information, see
).
Warning
There is a risk of explosion if the battery is replaced by an incorrect type.
Always dispose of used batteries according to the instructions accompanying
the battery.