Wacom GRAPHIRE CTE-630BT - Manual (Page 11)

11
11
Index Contents
Index Contents
CHARGING THE BATTERY
Before using the tablet battery for the first time, Wacom recommends that you plug in the power adapter and
allow the battery to charge. You can continue with the installation process and work with the tablet while the
battery is charging. The battery will take approximately five to six (5 to 6) hours to fully charge. Note that
fully charging or discharging the battery does not extend the battery life as Li-Ion batteries do not have a
memory.
To check the current battery charge status, open the Pen Tablet control panel and go to the T ABLET tab.
See working with tablet properties.
Power connector port.
To charge the battery, plug the round
end of the power adapter into the
tablet power connector port. Then
connect one end of the adapter’s
power cable to the power adapter, and
the other end to an active power
outlet.
Recharge the battery before it gets
too low – this will ensure the tablet
battery is always ready for mobile
operation
Note: Charge the battery whenever
its charge is low, as indicated by a
low battery alert on your screen.
When the power indicator light starts
flashing, the battery is nearly empty
and the tablet will soon cease to
function properly.
The charging indicator glows
orange when charging, and green
when fully charged.
Power connector port.