Testing your tools, Esting your tools, On to testing your tools – Wacom GRAPHIRE CTE-630BT User Manual

Page 46

Advertising
background image

46

46

Index

Contents

Index

Contents

TESTING YOUR TOOLS

If your tool does not work as you expect, it is a good idea to first check the assigned functions or to reset the
tool to its default condition using the Pen Tablet control panel.

1. Check the pen.

•

Move your pen across the active area of the tablet; the screen cursor should move in the
corresponding direction on your display screen.

•

Press the pen tip against the surface of the tablet. The power indicator light should turn from blue to
green.

•

Next, without applying pressure to the pen tip, hold the pen tip within approximately 5 mm (0.20 inch)
above the tablet surface and press the side switch. The power indicator light should again change
from blue to green.

•

Turn the pen over and press the eraser against the surface of the tablet; the power indicator light
should change from blue to green.

•

If not, you may have a defective pen or tablet. See technical support options.

2. Check the cordless mouse.

•

Move the cordless mouse across the active area of the tablet; the screen cursor should move in the
corresponding direction on your display.

•

Test the buttons on your cordless mouse by clicking each button. The tablet power indicator light
should turn green when a button is pressed.

•

If not, you may have a defective cordless mouse or tablet. See technical support options.

Advertising