Wybron pmn - Manual (Page 19)

Figure 6
90 - 250 VAC 50
/ 60 HZ
4 AMP SLO
-BLO AT 115 VAC
2 AMP SLO
-BLO AT 230 VAC
12 WAY POWER SUPPLY 19012
Figure 10
19
Power Supply hanger brackets
The Coloram II Power Supplies are shipped with hanger brackets to
allow pipe or truss mounting.
Follow these steps to install the hanger bracket.
1. Disconnect AC power from the Power Supply.
2. Place the Power Supply on it’s side on a flat surface.
3. Position the brackets as shown below.
4. Attach the bracket using a 3/16" Allen wrench and the supplied
screws.
Note: Use the supplied thumb screws to clamp the hanger brackets to
the desired pipe or truss.