Wrangler JEEP P5063 - Manual (Page 16)

P5063pr-0923
IMPORTANT! Use only a Power Wheels ® 6 volt battery with
A-style connector and built-in thermal fuse. Use of any other
battery will damage your vehicle. Make sure that you charge
the battery for at least 18 hours using the enclosed Power
Wheels
® Super 6 volt charger before operating your vehicle
for the first time. Charge the battery for at least 14 hours after
each use of the vehicle. Never charge the battery longer than
30 hours. Failure to follow these instructions may damage your
battery and will void your warranty.
• Using a slotted screwdriver, turn each lock fastener 1 /
4
turn to
the unlocked position.
• Lift the hood to access the battery compartment.
• Slide the battery retainer open.
• Place the battery in the battery compartment and release the
battery retainer.
• Lower the hood on the vehicle. Using a slotted screwdriver,
turn each lock fastener 1 / 4 turn to the locked position.
IMPORTANT! Remember to keep the lock fasteners locked
at all times to prevent children from accessing the battery
compartment.
Hood
Hood
Power Wheels ®
6 Volt Battery
Slide Battery
Retainer
Motor Harness
Connector
Battery
Connector
Locked Unlocked
Locked Unlocked
• Plug the battery connector into the motor harness connector.
Note: If the battery connector will not plug into the motor
harness connector, turn it over and try again! Do not force the
battery connector into the motor harness connector.
16
BATTERY INSTALLATION H
1
3
2
4
Incorrect
GAP
Correct
NO GAP
P5063a-0920