Weider WESY41080 - Manual (Page 23)

23
CHANGING THE WEIGHT SETTING
The home gym system features two weight stacks. The
one weight stack is connected to the lat, upper, and lower
pulley stations. The other weight stack is connected to the
butterfly and press arms and the leg press.
To change the weight setting of either weight stack, insert
a Weight Pin (93) under the desired Weight (90). Insert
the Weight Pin until the bent end of the Weight Pin is
touching the Weights, and turn the bent end downward.
The weight setting of either weight stack can be changed
from 6.5 pounds to 106.5 pounds, in increments of 12.5
pounds. Note: Due to the cables and pulleys, the
amount of resistance at each exercise station may
vary from the weight setting. Use the WEIGHT
RESISTANCE CHART on page 27 to find the approxi-
mate amount of resistance at each weight station.
ATTACHING THE LAT BAR OR HANDLE TO THE HIGH
PULLEY STATION
Attach the Lat Bar (36) to the High Cable (85) with a
Cable Clip (33). For some exercises, the Chain (34)
should be attached between the Lat Bar and the High
Cable with two Cable Clips. Adjust the length of the
Chain between the Lat Bar and the High Cable so the
Lat Bar is in the correct starting position for the exer-
cise to be performed.
The Handle (96) can be attached in the same manner.
ATTACHING THE LAT BAR OR HANDLE TO THE LOW
PULLEY STATION
Attach the Lat Bar (36) to the Low Cable (86) with a Cable
Clip (33). For some exercises, the Chain (34) should be
attached between the Lat Bar and the Low Cable with two
Cable Clips. Adjust the length of the Chain between
the Lat Bar and the Low Cable so the Lat Bar is in the
correct starting position for the exercise to be per-
formed.
The Handle (96) can be attached in the same manner.
The instructions below describe how each part of the home gym system can be adjusted. Refer to the exercise
poster accompanying this manual to see how the home gym system should be set up for each exercise.
IMPORTANT: When attaching the lat bar or handle, make sure that the attachments are in the correct
starting position for the exercise to be performed. If there is any slack in the cables or chain as an exer-
cise is performed, the effectiveness of the exercise will be reduced.
96
85
33
34
36
93
93
90
96
86
33
34 36
How to Use the Home Gym System