weber 63601 - Manual (Page 3)

3
Step 2
Remove packaged parts
Remove and unpackage glass door assemblies,
warming rack, Weber Warm-Up Basket, 2 cooking
grates, corrugated box (which contains cookbook and
warranty card), 8 short stainless steel Flavorizer Bars
and 5 long stainless steel Flavorizer Bars. Figure 2.
Note - Be sure no packaging material is left in the
cooking box before reinstalling parts.
Step 1
Removal of all tape
Remove tape from the following locations:
front and rear of side work tables
swing tables
swing table slide bars
bottom tray beneath the cooking box
bottom accessory trays
Assembly
Supplies needed
You will need a soap and water solution to check for gas
leaks. (See Step "Check for gas leaks.")
Refer to exploded view if replacement parts are needed.
Your LP tank is shipped empty for safety. After setting
the LP fuel scale you will need to fill it. (See Step "Fill
LP tank.")
While we give much attention to our products, unfor-
tunately an occasional error may occur. If a part is
missing, do not go back to the store. Call the Weber
Customer Service Center toll free 1-800-446-1071 to
receive immediate assistance. Have your owner’s
manual and serial number of the barbecue available
for reference.
Figure 1
Figure 2
Warming basket
Weber Warm-Up
Basket
Cooking grates
Short Stainless
Steel Flavorizer
Bars
Long Stainless
Steel Flavorizer
Bars
Remove packaging material from the side burner.
Figure 3.
protective plastic
on the stainless
steel lid
protective paper
cap on the burner
Figure 3
Corrugated box
containing glass
doors