weber 63601 - Manual (Page 7)

7
Step 10
Fill LP tank
Note - The LP tank manufacturer is responsible for the
materials, workmanship and performance of the tank. If
the tank has a defect, malfunctions, or you have a
question regarding the tank, call the tank manufacturer's
customer service center. The phone number is on the
warning decal which is permanently attached to the
tank. If the tank manufacturer has not resolved the issue
to your satisfaction, then call Weber-Stephen Products
Co., Customer Service Center.
To fill, take the LP tank to an RV center or look-up gas-
propane in the phone book for other sources of LP gas.
ƽ
WARNING: We recommend that your LP tank be
filled at an authorized LP gas dealer by a qualified
attendant, who fills the tank by weight.
IMPROPER FILLING IS DANGEROUS.
Tell your LP dealer that this is a new LP tank. The air
must be removed from a new LP tank before the initial
filling. Your LP tank dealer is equipped to do this.
ƽ
CAUTION: If you exchange your LP tank, make
sure you get a similar tank in return. Your LP tank is
equipped with a quick-disconnect valve. Other LP
tanks are not compatible with your barbecue
connection.
The LP tank must be installed, transported and stored in
an upright position. LP tank should not be dropped or
handled roughly.
Never store or transport the LP tank where
temperatures can reach 125° Fahrenheit (too hot to hold
by hand – for example: do not leave the LP tank in a car
on a hot day).
For full instructions on safe handling of LP tanks, see
Section "Safe handling tips for LP gas,” in the Operating
Guide.
Step 11
Remove control panel
Pull the right hand swing table up. Stand to the right
side of the barbecue. Slightly pull back both side
burner locks. Slide the side burner out from the control
panel. Figure 14. Do not disconnect the hose.
Figure 14
View from top
Side view