Woods Equipment 7000 - Manual (Page 40)

38 Assembly
MAN0137 (9/14/01)
Assembly Instructions Cont’d
Install Rear Gauge Wheel
1. Assemble gauge wheel with grease fitting facing
outward for lubrication access.
1. Insert sleeve (68) through wheel (6).
2. Place washer (63) on bolt (69) and insert through
sleeve in wheel and rear gauge wheel arm (7).
3. Secure with flanged locknut (65).
4. Repeat for opposite side.
6. Gauge wheel
7. Rear gauge wheel arm
63. 1/2" Flat washer
65. 1/2" Flanged locknut
68. 1/2 x 3/4 x 3-3/8" Sleeve
69. 1/2 x 4-1/2" Bolt
Figure 33 Rear Gauge Wheel Installation
Install Mid-PTO Driveshaft
IMPORTANT
■ Stake end of keyway to secure key.
1. Insert key (3) into gearbox (2) input shaft.
2. Install driveshaft (1) onto gearbox shaft and
secure with spirol pin (4).
21. Driveshaft assembly
22. Gearbox
46. 1/4 x 1/4 x 7/8" Key
60. 3/8 x 1-1/2" Spirol pin
Figure 34 Driveshaft Installation