Woods Equipment 7000 - Manual (Page 44)

42 Assembly
MAN0137 (9/14/01)
Assembly Instructions Cont’d
PRE-DELIVERY CHECK LIST DELIVERY CHECK LIST
(DEALER’S RESPONSIBILITY)
Inspect the equipment thoroughly after assembly to
make sure it is set up properly before delivering it to
the customer. The following check list is a reminder of
points to inspect. Check off each item as it is found
satisfactory, corrections are made, or services are
performed.
___ Check all bolts to be sure they are properly
torqued.
___ Check that all cotter pins and safety pins are
properly installed. Replace if damaged.
___ Check and grease all lubrication points as iden-
tified in “Service, lubrication information
___ Check the level of gearbox fluids before deliv-
ery. Service, if required, as specified in the “Ser-
vice, lubrication information.”
___ Check that blades have been properly installed.
(DEALER’S RESPONSIBILITY)
___ Show customer how to make adjustments and
select proper PTO speed.
___ Check mower attitude and belt alignment.
___ Instruct customer how to lubricate and explain
importance of lubrication.
___ Point out the safety decals. Explain their mean-
ing and the need to keep them in place and in
good condition. Emphasize the increased safety
hazards when instructions are not followed.
___ Point out all guards and shields. Explain their
importance and the safety hazards that exist
when not kept in place and in good condition.
___ Present Operator's Manual and request that
customer and all operators read it before oper-
ating equipment. Point out the manual safety
rules, explain their meanings and emphasize
the increased safety hazards that exist when
safety rules are not followed.
___ Explain to customer that when equipment is
transported on a road or highway, a Slow Mov-
ing Vehicle (SMV) sign should be used to pro-
vide adequate warning to operators of other
vehicles.