Whirlpool 6LSR7244EQ0 - Manual (Page 13)

13
TROUBLESHOOTING
C
OMMON WASHING PROBLEMS
( CONT
.
)
Solution...
• This is normal.
• This is normal.
• Plug in power cord.
• Turn Cycle Control knob to the
right slightly and pull to start.
• Clean screens.
• Turn on water.
• Reverse hoses.
• Straighten hoses.
• Plug in power cord.
• Check electrical source or call
electrician.
• Replace fuse or reset circuit
breaker. If problem continues,
call electrician.
• Do not use extension cords.
• Turn knob to the right slightly
and pull to start.
• Set and pull out knob.
• Allow cycle to continue.
• Wash smaller loads.
• This is normal.
• This is normal.
• This is normal.
• Push tub to center before
starting.
• This is normal.
• Ensure front feet are installed
and nuts tightened. Level
washer. Reset rear leveling legs.
See Installation Instructions.
Cause...
• Gears engaging after drain and
before spin.
• Upper part of agitator clicks during wash.
• Power cord not plugged in.
• Cycle Control knob is not lined up.
• Water inlet valve screens are plugged.
• Water is turned off.
• Hot and cold hoses are reversed.
• Inlet hoses are kinked.
• Power cord not plugged in.
• No power at plug.
• Fuse blown or circuit breaker open.
• Using an extension cord.
• Cycle Control knob is not lined up.
• Cycle Control knob not pulled out.
• Washer at pause in Permanent Press
cycle (approximately 2 minutes).
• Machine is overloaded.
• The top of the agitator moves only in
one direction.
• The top of the agitator is loose.
• The top of the agitator is much higher
than the highest water level. This creates
a perception of the washer not being full.
• Tub is pulled forward when unloading.
• Tub moves.
• Washer not level.
Problem...
Washer makes noise
(cont.)
Won’t fill/rinse/agitate
or wrong temperature
Washer stops
Agitator operation
Water level seems
too low or washer
not completely filling
Washer tub is crooked
continued on next page