White Outdoor Z - 180 User Manual
Page 28
28
Figure 17
REPLACING THE HEAD LAMP BULB
1.
Remove the ignition key from ignition switch.
2.
Detach the bottom of the rubber boot cover on the drive handles.
3.
Slide the boot cover all the way up (toward the drive handles) to access the drive handle bolts.
4.
Remove both bolts securing the drive handles.
5.
Remove the drive handles and the rubber boot.
6.
Remove the four bolts securing the retaining plate to the Control Tower cover.
7.
Pull up on the Control Tower cover and slide up and over the Control Tower.
8.
Locate the rear of the light fixture where the wire attaches. (See Figure 18)
Figure 18
9.
Remove the wire from the light bulb assembly. (See Figure 18)
10. Squeeze the tab on the connector that attaches the wire to the light bulb assembly.
11. Pull the wire from the light bulb assembly.
12. Turn the light bulb assembly counterclockwise to release it from the light fixture.
13. Carefully pull the light bulb out of the light fixture.
Hydraulic
Oil Filter
Left Transmission Drain Plug
Light Reflector
Light Bulb
Connector
Look Here