Weider WESY2966.0 - Manual (Page 9)

9
9. Attach a Pulley Bracket (17) to the indicated
“U”-channel (18) with an M10 x 132mm Button
Bolt (72), two M10 Washers (59), and an M10
Nylon Locknut (56).
Wrap the Long Cable (42) over a 90mm Pulley
(38). Attach the Pulley inside the Pulley Bracket
(17) with an M10 x 42mm Button Bolt (71) and
an M10 Nylon Locknut (56).
8. Wrap the Long Cable (42) under a 90mm
Pulley (38). Attach the Pulley, a Cable Trap
(39), and two Half Guards (37) to the Base (2)
with an M10 x 52mm Patch Screw (89) and an
M10 Washer (59).
Make sure that the Cable
Trap is oriented to hold the Cable in the
groove of the Pulley.
7
8
59
38
37
42
Slot
39
10
37
89
42
37
39
38
59
37
89
2
56
56
72
59
71
42
18
59
17
38
9
7. Note: This step may be easier if the resist-
ance system is tipped forward as shown.
Route the Long Cable (42) around a 90mm
Pulley (38). Attach the Pulley, a Half Guard
(37), a Cable Trap (39), an M10 Washer (59),
and another Half Guard to the Rear Frame (10)
with an M10 x 52mm Patch Screw (89).
Do not
fully tighten the Button Bolt. Make sure the
90mm Pulley is inserted into the indicated
slot in the Rear Frame. Make sure that the
Cable Trap is oriented to hold the Cable in
the groove of the Pulley.
10. Wrap the Long Cable (42) under a 90mm
Pulley (38). Attach the Pulley, a Cable Trap
(39), and two Half Guards (37) to the Base (2)
with an M10 x 52mm Patch Screw (89) and an
M10 Washer (59).
Make sure that the Cable
Trap is oriented to hold the Cable in the
groove of the Pulley.
Note: The Half Guards (37) attached in this
step will overlap the Half Guards attached in
step 8.
10
42
37
39
38
59
37
89
2