Whirlpool CMT102SG - Manual (Page 12)

12
GETTING TO KNOW YOUR MICROWAVE OVEN
Setting the clock
When your microwave oven is first plugged
in, or after a power failure, the display will
show “ : ”. If a time of day is not set, “ : ” will
stay on the display until you set the clock or
another function.
NOTES:
• You can only set the clock when the oven
is not in use.
• If you enter an incorrect time, three tones
will sound, “Err,” then “0” will appear on the
display. Re-enter the correct time.
• If you touch OFF/CANCEL while setting
the clock, the clock will return to the time
already on the display.
To set time:
1. Choose the setting.
2. Enter the time of day.
Example for 5:30:
3. Touch CLOCK/SET or
START/ENTER.
TOUCH
TOUCH
Using the minute
timer
Your microwave oven can be used as a
kitchen timer. Use the minute timer for timing
up to 99 minutes, 99 seconds.
1. Touch “0.”
2. Enter the time to be
counted down.
Example for 3 minutes
3. Start the countdown.
NOTE: At any time touch OFF/CANCEL
to cancel the minute timer.
At end of timer cycle:
Five tones will sound and the display will
show “End”.
Two tones will sound every minute
until you open the door or touch
OFF/CANCEL. The display will then
return to the time of day.
NOTES:
• The minute timer can be used to set delayed
start time by following steps 1 and 2 above,
then set cook time as described in the
“Cooking with more than one cycle” section.
• You cannot set the minute timer while
using the oven.
TOUCH
TOUCH
TOUCH
4393788v06(c98).qx 5/6/98 1:58 PM Page 12