Weider WEBE11920 - Manual (Page 6)

6
5. Lubricate an M10 x 70mm Bolt (31). Attach the
Leg Lever (8) to the Front Leg (3) with the Bolt
and an M10 Nylon Locknut (11). Do not over-
tighten the Nylon Locknut; the Leg Lever
must be able to pivot freely.
5
3. Attach the Front Leg (3) to the Bench Frame (1)
using two Joint Plates (12), four M10 x 70mm
Bolts (31), and four M10 Nylon Locknuts (11).
Tighten the M10 Nylon Locknuts (11) used in
steps 1–3.
Insert the Bench Knob (21) into the Bench Frame
(1) and tighten it fully.
6. Press four 25mm Square Inner Caps (27) into the
ends of the Backrest Frames (33).
Attach the Backrest Bracket (5) to the Backrest
Frames (33) with four M10 x 45mm Bolts (40),
four M10 Washers (6), and four M10 Nylon
Locknuts (11). Do not tighten the Nylon
Locknuts yet.
3
1
3
11
12
12
21
31
6
Lubricate
8
11
31
3
27
27
33
11
11
40
40
40
5
6
6
6
6
26
26
26
25 41
41
9
72
38
39
34
4
23
4. Press three 45mm Square Inner Caps (26) into
the Leg Lever (8). Press a 25mm Round Inner
Cap (23) into the indicated end of the Weight
Tube (9).
Attach the Weight Tube (9) to the Leg Lever (8)
with an M8 x 55mm Bolt (38), two M8 Washers
(41), a 10mm Spacer (39), and an M8 Nylon
Locknut (34).
Press an Angled Outer Cap (25) onto the back
end of the Weight Tube (9).