Assembly 29, Assembly instructions, Warning caution – Woods Equipment PRD6000 User Manual

Page 29

Advertising
background image

Assembly 29

MAN0475 (9/21/2005)

ASSEMBLY INSTRUCTIONS

DEALER SET-UP INSTRUCTIONS

Assembly of this mower is the responsibility of the
Woods dealer. If should be delivered to the owner com-
pletely assembled, lubricated, and adjusted for normal
cutting conditions.

Complete Dealer Check Lists on page 33 when you
have completed the assembly.

The mower is shipped partially assembled. Assembly
will be easier if components are aligned and loosely
assembled before tightening hardware. Recommended
torque values for hardware are located on page 45.

Select a suitable working area. Open parts boxes and
lay out parts and hardware to make location easy.
Refer to illustrations, accompanying text, parts lists and
exploded view drawings.

„

Before working underneath, carefully read Oper-

ator’s Manual instructions, disconnect driveline,
raise mower, securely block up all corners with
jackstands, and check stability. Secure blocking
prevents equipment from dropping due to hydrau-
li c l e ak down , hy dr a uli c sy s tem fai lu re s , or
mechanical component failures.

„

Always wear relatively tight and belted clothing

to avoid getting caught in moving parts. Wear
sturdy, rough-soled work shoes and protective
equipment for eyes, hair, hands, hearing, and head;
and respirator or filter mask where appropriate.

Uncrate Mower

1. Remove sides and top of mower shipping crate.

2. Remove lag screws and brackets that secure

mower to crate base.

3. Remove driveshaft wired to mower deck.

Install Front Offset Links

1. Loosen lock nuts at lower hitch point and rotate

offset link up off of gearbox as shown.

2. Tighten nut securely.

3. Repeat for opposite side.

NOTE: Front link with the PTO storage bracket should
be installed on right side of mower as shown in Figure
28.

Figure 28. Front Offset Links Installed

Install Rear Offset Links

1. Loosen nut (44) at rear frame lug and rotate offset

link (9) up as shown in Figure 29.

2. Repeat for opposite side.

3. Do not tighten at this time.

9.

Link, rear offset

44.

Nut, flanged lock 1/2 NC

Figure 29. Right Rear Offset Link Installed

WARNING

CAUTION

PTO Storage Bracket

Rear Offset
Link

Front

Offset

Front Offset
Link

Lock Nuts

Link

CM905

44

9

(Rev. 12/23/2005)

Advertising
This manual is related to the following products: