Woods Equipment PRD6000 - Manual (Page 43)

Parts 43
MAN0475 (9/21/2005)
MULCHING KIT (OPTIONAL)
x
x
x
x
2
1
REF PART QTY DESCRIPTION
A 1019430 1 PRD6000 Mulching kit
A 1019431 1 PRD7200 Mulching kit
A 1019432 1 PRD8400 Mulching kit
1 6100 * - 1/2 x 1-1/4 Cap screw GR5
2 11900 * - 1/2 Flanged lock nut
* Obtain Locally
INSTALLATION INSTRUCTIONS
1. Using the tractor 3-point, or suitable lifting device, carefully lower deck onto 4" - 6" high blocks
at each corner.
2. Make sure deck is stable before proceeding.
3. Wear safety glasses or goggles to prevent eye injury while drilling holes.
4. Clamp mulching kit in place. Make sure baffles are completely closed-off by the kit.
5. Inspect fit-up to confirm that there will be no contact between blades and kit at any time. Failure
to do so will result in product damage and possible injury.
6. Mark the holes to be drilled.
7. Once marked, remove the kit and carefully drill the holes out using a 9/16" drill bit.
8. After holes are drilled, bolt the kit into place torqueing bolts to 85 lbs-ft.
NOTE: Use high lift blades for best performance if tractor does not have
enough horsepower for the high lift blades, then use low lift blades.
(Rev. 1/12/2007)