Connecting power (if required), Configuring your scanner, Removing the interface cable – Wasp Bar Code WPS100 User Manual
Page 20
1-4
Wasp WPS100 Product Reference Guide
Connecting Power (if required)
If your host does not provide power to the scanner, you will need an external power
connection to the scanner:
1. Connect the interface cable to the back of the scanner, as described in
2. Connect the other end of the interface cable to the host (refer to your host manual
to locate the correct port).
3. Plug the power supply into the power jack on the interface cable.
4. Plug the other end of the power supply into an AC outlet.
Configuring Your Scanner
Configure your scanner using the bar codes included in this manual. Refer to
for information about programming your scanner using bar code menus.
The scanner supports Keyboard Wedge and USB interfaces. Each host specific chapter
describes how to set up each of these connections.
Removing the Interface Cable
To remove the interface cable:
1. Unplug the installed cable’s modular connector by depressing the connector clip
and gently pulling back.
2. Follow the steps for
Installing the Interface Cable
on page 1-3 to connect a new
cable.