Wasp Bar Code WPS100 - Manual (Page 429)

A-1
Appendix A
Standard Default Parameters
Table A-1. Standard Default Parameters Table
Parameter Default
Page
Number
User Preferences
Set Default Parameter All Defaults 4-5
Beeper Tone High 4-6
Beeper Volume High 4-7
Volume Change Trigger Delay 5 sec 4-8
Laser On Time 3.0 Sec 4-9
Beep After Good Decode Enable 4-10
Low Power Blink Blink 4-11
Scan Pattern Mode Rastering 4-12
Single-Line Aim Duration 2 sec 4-13
1
User selection is required to configure this interface and this is the most common selection.