Warwick X7220 - Manual (Page 9)

Parity
Enable Parity
Odd/Even
Odd, Even or No Parity can be selected .
RF Channel On of 17 RF Frequency can be selected.
Key Transmitter
The transmitter carrier can be switched on. A distant modem can them use the RSSI bar
graph to check the signal strength.
RSSI Displays a Bar Graph of Relative Signal Strength.
Txmitter Speed
Sets the transmission speed: S = 5Kbps, F= 10Kbps
Address Mode
Enables Modem Address. This can be used in with the ATT Instruction to pass data to specific
modems.
TX Address Set Transmitter Address.
RX Address
Set Receiver Address.
RF Sensitivity
Sets the Receiver Sensitivity
Restore Defaults
Set Factory Defaults.
Exit without Save Return to Modem
Advanced Menu
Return to Main Menu
Display Main Menu by pressing the left Arrow Key
Enable AT Instructions
AT instruction are enabled. The modem will act on AT instruction present as the first
set of characters in a data string.
TX Priority
Data will be transmitted when RF noise is present at the receiver.
Display Journal
Used for test diagnostics.
Packetise Data
Data is formed into packets with error detections and Acknowledgments. When the
modem has received a full packet of data or at the end of a data string CTS is taken
low to suspend data from the host.
Number of Retries
Sets number of retries
Packet Size
Sets the number of bytes in the packet size.
Logger Mode
Data will be stored in the modems memory until interrogated by a Distant Modem
Enable Remote Access
Allows distant Modem to change settings.
Access Remote Modem
Displays settings of remote
Engage Rpt Path
Enables the data repeater path entered below.
Set Repeater Path
Sets the Modem ID numbers of the required repeater path.