Weider WEBE96490 - Manual (Page 14)

14
24. Make sure all parts are properly tightened before
you use the weight bench. The use of all remain-
ing parts will be explained in Adjusting the Weight
Bench starting below.
23. Attach the Curl Pad (44) to the Curl Post (42) with
two M6 x 16mm Screws (3).
23
3
44
3
42
USING THE WEIGHT RESTS
Before beginning an exercise, move the Weight Rests
(21) or the Small Weight Rests (26) to a set of holes in
the Uprights that is best suited for that exercise. The
selected holes should represent the lowest point to which
you want your barbell to go during the exercise. Perform
the exercise as shown in the accompanying EXERCISE
GUIDE. Note: Make sure the locking clips on the
Weight Rests snap into place around the Uprights.
26
21
Locking
Clip
This section explains how to adjust the weight bench. See the EXERCISE GUIDELINES on page 17 for impor-
tant information on how to get the most benefit from your exercise program. Also, refer to the accompanying
exercise poster to see the correct form for each exercise.
Inspect and tighten all parts each time you use the weight bench. Replace any worn parts immediately. The
weight bench can be cleaned with a damp cloth and a mild, non-abrasive detergent. Do not use solvents.
Adjusting the Weight Bench
WARNING: Always set both Weight Rests at the
same height.