weber 100 - Manual (Page 9)


Make sure the igniter port hole (A) lines up with
the arrow tab (B) on the igniter box.
• Check that the ignition button pushes the
igniter (button) down, and returns to the up
position.
If the ignition system still fails to light, contact the
Customer Service Representative in your area
using the contact information on our web site.
Log
onto www.weber.com ® .
MAIntEnAnCE
1
(a) (a) a.
b.
2
(2)
(1)
Ignition System Operations
If the ignition system fails to ignite the burner, light
the burner with a match. If the burner lights with a
match, then check the ignition system.
• Check that both the white
(1) and black(2)
ignition wires are attached properly.
1.
2.
Replacing Burner Tube
1) Your Weber ® Gas Grill must be OFF and
cool.
2) Unscrew and remove butane/propane
cartridge/cylinder from the valve/regulator
assembly.
3) Open the lid.
4) Remove cooking grate.
5) Unscrew and remove the 1/4 x 20-inch
stainless steel hex nut and stainless steel
washer that holds the burner tube inside the
cook box
(a).
6) Carefully slide the burner tube out from the
cook box.
m Caution: the burner openings(1) must
be positioned properly over the valve
orifices(2).
7) To reinstall the burner, reverse steps 5) to 7).
Weber ® Spider /Insect screens
Your Weber ® gas barbecue, as well as any
outdoor gas appliance, is a target for spiders
and other insects. They can nest in the venturi
section(1) of the burner tube. This blocks the
normal gas flow, and can cause the gas to flow
back out of the air shutter. This could result in a
fire in and around the air shutter, causing serious
damage to your barbecue.
The burner tube air shutter is fitted with a
stainless steel screen
(1) to prevent spiders and
other insects from accessing the burner tubes
through the air shutter openings.
We recommend that you inspect the Spider/
Insect screen at least once a year. (See
“Annual Maintenance” section) Also inspect
and clean the the Spider/Insect screen if any
of the following symptoms should ever occur:
1) The smell of gas in conjunction with the
burner flames appearing yellow and lazy.
2) Barbecue does not reach temperature.
3) Barbecue heats unevenly.
4) One or more of the burners do not ignite.
m DANGER
Failure to correct symptoms may result
in a fire, which can cause serious bodily
injury or death, and cause damage to
property.
(1)
(1)
Annual Maintenance
Inspection and cleaning of the Spider/
Insect screen
If there is dust or dirt on the Spider/Insect screen,
remove the burner for cleaning the screen.
Brush the Spider/Inspect screen, lightly, with a
soft bristle brush (i.e. an old toothbrush).
If the Spider/Insect screen becomes damaged or
cannot be cleaned, contact the Customer Service
Representative in your area using the contact
information on our web site. Log onto
www.weber.com
® .
m CAUTION: Do not clean the Spider/Insect
screen with hard or sharp tools. Do not
dislodge the Spider/Insect screen or
enlarge the screen openings.
Lightly tap the burner to get debris and dirt out of
the burner tube. Once the Spider/Insect screen
and burner is clean, replace the burner.