Western Telematic IPS-800-D20 - Manual (Page 10)

2-2
IPS-800/1600-D20 Series - User’s Guide
➂ Bus "A" Switched Outlets and Indicator Lights: AC Outlets that can
be switched On, Off or rebooted in response to user commands.
• IPS-800-D20: Four (4) NEMA 5-15R Outlets with indicator lights. 20
Amps total load per circuit; 15 Amps load per outlet.
• IPS-800E-D20: Four (4) IEC320-C13 Outlets with indicators. 20
Amps total load per circuit; 15 Amps load per outlet.
• IPS-1600-D20: Eight (8) NEMA 5-15R Outlets with indicators. 20
Amps total load per circuit; 15 Amps load per outlet.
• IPC-1600E-D20: Eight (8) IEC320-C13 Outlets with indicators. 20
Amps total load per circuit; 15 Amps load per outlet.
➃ Bus "B" Switched Plugs and Plug Indicators: AC Outlets that can be
switched On, Off or rebooted in response to user commands. Includes
same components listed in item 3 above.
➄ Default Button: This button can be used to either reset the unit to default
parameters or manually toggle all plugs On or Off:
• Default Parameters: With the Main Power switch set in the Off
position, press and hold the Default Button, then set the Main Power
switch in the On position and release the Default Button. All menu
defined parameters will be reset to default values.
• Manual Plug Toggle: Press the Default Button and hold it down for
three seconds. All IPS power outlets will be toggled On or Off.
Note: If desired, the Default Button’s manual plug control
capabilities can also be disabled as described in Section 5.3.1.
➅ Unit Status Indicators: Two LED Indicators which function as follows:
• ON: Lights when power is applied to the IPS Unit.
• RDY: Flashes continuously when the IPS is ready to recieve
commands.
➆ Network Port and Activity Indicator: An RJ45 Ethernet Port
for connection to your TCP/IP network. The default IP Address is
192.168.168.168, for more information, please refer to Section 5.3.4. The
Activity Indicator flashes to indicate activity at the Network Port.
➇ Main Power Switch: Applies power to the IPS Unit. This switch must
be "On" in order for the IPS to function. Note that this switch is not used
to set the On/Off status of the switched outlets.
➈ COM / RS232 Port: A DB9, RS232 serial port (DTE), for connection to
a local terminal or external modem, as described in Section 4.3.