Westinghouse L1920NW - Manual (Page 4)

- 2 -
GETTING STARTED
1.Setting up the monitor
1.1 Take out the monitor, stand and monitor base from the package.
1.2 Grasp the monitor with both hands and then slide the
monitor into the neck. (Make sure the direction of the neck
is correct)
2.Connecting signal cable
2.1 Switch off your computer
2.2 Connect the signal cable to the D-SUB or DVI port at the
rear of the monitor and tighten the connector screws
2.3 Connect the other end of signal cable to the computer's
VGA port or DVI port and tighten the connector screws.
2.4 Note: Ensure the display setting does not exceed
18.5" 1366X768@60Hz, 21.6" 1920x1080@ 60Hz.
3.Connecting audio cable (with audio option)
3.1 Plug the audio cable into the AUDIO port at the rear of
the monitor.
3.2 Plug the other end of the audio cable into the audio
port of your computer or other audio source.
Monitor installation Package contents
Before beginning, ensure that the carton contains the following items:
1. LCD Monitor
2. Monitor Base and Neck
(the shape of base may vary according to the monitor model)
3. Power Cord (plug may vary according to the electrical standards
for your area)
4. Analog Signal Cable
5. Digital Signal Cable (optional)
4.Connecting power
4.1 Plug the female end of the power cord into the
POWER port at the rear of the monitor.
4.2 Plug the male end of the power cord into a power
outlet.
5.Switching on
Switch on your computer.
You should now be able to see the picture. If not , refer
to the trouble shooting section of this guide.
6. Audio Cable (optional)
7. CD-ROM (contains user manual)
8 .Quick Installation Guide
POWER AUDIO D-SUB DVI