Gas instructions – weber GENESIS E/S-310/320 User Manual

Page 11

Advertising
background image

11

WWW.WEBER.COM

®

11

Check:

1) Hose-to-manifold

connection.

ƽ WARNING: If there is a leak at connection (1), retighten the

fi tting with a spanner and recheck for leaks with soap-and-
water solution. If a leak persists after retightening the fi tting,
turn OFF the gas. DO NOT OPERATE THE GRILL. Contact
the Customer Service Representative in your area using the
contact information on our web site. Log onto
www.weber.com

®

.

2) Regulator-to-cylinder

connection.

3)

The hose-to-regulator connection.

4) Valves-to-manifold

connections.

ƽ WARNING: If there is a leak at connections (2), (3) or (4),

turn OFF the gas. DO NOT OPERATE THE GRILL. Contact
the Customer Service Representative in your area using the
contact information on our web site. Log onto
www.weber.com

®

.

When leak checks are complete, turn gas supply OFF at the source and rinse

connections with water.

(2)

(3)

(4)

(1)

310

GAS INSTRUCTIONS

ƽ WARNING: You should check for gas leaks every time you

disconnect and reconnect a gas fi tting.

Note: All factory-made connections have been thoroughly checked for gas leaks. The
burners have been fl ame-tested. As a safety precaution however, you should recheck
all fi ttings for leaks before using your Weber

®

Gas Barbecue. Shipping and handling

may loosen or damage a gas fi tting.

ƽ WARNING: Perform these leak checks even if your barbecue

was dealer- or shop-assembled.

You will need: a soap-and-water solution, and a rag or brush to apply it.

Note: Since some leak test solutions, including soap and water, may be slightly
corrosive, all connections should be rinsed with water after checking for leaks.

If your grill has a side burner make sure the side burner is off.
To perform leak checks: open cylinder valve by turning the cylinder valve hand-wheel
counter-clockwise.

ƽ WARNING: Do not ignite burners when leak checking.

Check for leaks by wetting the connections with the soap-and-water solution and
watching for bubbles. If bubbles form or if a bubble grows, there is a leak.

ƽ DANGER

Do not use an open fl ame to check for gas leaks. Be sure
there are no sparks or open fl ames in the area while you
check for leaks. Sparks or open fl ames will result in a fi re or
explosion, which can cause serious bodily injury or death
and damage to property.

CHECK FOR GAS LEAKS

*The grill illustrated may
have slight differences to
the model purchased.

Advertising